HydroFloss Hose Assembly Installation Instructions

Update: Video instructions:

 

* Link to the page where you can get the hose and handle assembly part:

http://www.toothygrinsstore.com/Hydro-Floss-Hose-Assembly-p/hoseassemblyforhydrofloss01.htm



Written Directions


These directions were sent to me by a customer, who successfully replaced his hose assembly.


Please be aware:  Toothy Grins Store cannot and does not warranty or guarantee these instructions.  If you follow them, you acknowledge that you do so at your own risk.

I generally tell folks to only do this if they have good mechanical skills.  






Here is what a customer sent in:  

Replacement Hydro floss irrigator and hose assembly arrived very quickly.

• It only took 10 - 15 minutes to replace the old one and start it up. 
•  
• Remove 4 base screws. 
•  
• Remove top cover and hose guide. 
•  
• Remove pressure adjusting assembly. 
•  
• Slide compression fitting off with small screwdriver, remove hose from unit. 
•  
• Reassembly is simply the reverse. 
•  
• Set the compression fitting on new hose. 
•  
• Press new hose into the hose nipple and press compression fitting in place. 
•  
• Replace pressure adjusting unit while aligning the gears on control knob. 
•  
• Replace hose guide and top cover. 
•  
• Install 4 screws into the base. 
•  
• Thanks for a great product and quick delivery.

--------------------------------------------------------------------------------------------------------------------------


I hope that you found the experience of this person to be helpful and useful?

You can find the hose assembly here

Sincerely,

David Snape

PS:   Get your free guide to stopping bad breath   or gum disease


PPS: if you have comments, opinions, questions or something to add to this page , please use the "Enter Comment Here" section below